Free tool

Mic test

Check that your microphone works and how much of the room it hears along with your voice. It all runs in your browser, and nothing gets uploaded.

Press start, then allow microphone access when your browser asks.

Your audio stays on this device. Nothing is uploaded or saved.

Level −∞ dBPeak −∞ dB
  1. 01 · Room noise

    Stay quiet for 3 seconds so we can hear what the mic picks up when nobody is talking.

  2. 02 · Your voice

    Talk for 5 seconds the way you would on a call or a recording. You can read this out: "I'm checking my mic before I hit record, and I'll play this back to hear how it sounds."

How to read your results

All three numbers are in dBFS. Zero is the loudest level your computer can record, and everything below it is negative. The closer to zero, the louder.

ReadingWhat it measuresGoodWorth fixing
Room noiseThe level while nobody talks, such as a fan or traffic outsideBelow −60 dBAbove −45 dB
Voice peakThe loudest moment while you talk−20 to −6 dBAbove −1 dB (clipping) or below −35 dB
Voice above noiseThe gap between your voice and the room40 dB or moreUnder 25 dB

Room noise on its own can fool you, because turning the gain down makes the room read quieter and your voice too. The gap between the two is the number that tells you how clean a recording will sound.

Mic not working?

The browser blocked it

Click the icon to the left of the address bar, set Microphone to Allow and reload the page. If you clicked Block by mistake earlier, the browser remembers it until you change it there.

Windows

Open Settings, then Privacy & security, then Microphone. Turn on Microphone access and Let desktop apps access your microphone, since your browser counts as a desktop app. Then go to System, Sound and check that the right input is picked and its volume isn't near zero.

Mac

Open System Settings, then Privacy & Security, then Microphone, and turn on your browser. Quit the browser and open it again for the change to stick.

Another app has it

Zoom, Discord or a recording app can hold on to an audio interface. Close them and press Try again. If your mic still doesn't show up in the list, unplug it and plug it back in.

XLR mics

An XLR mic can't plug into a computer by itself. It needs an audio interface, and a condenser mic also needs 48V phantom power switched on there. If the meter barely moves, turn up the gain knob on the interface before you blame the mic.

Shopping for a mic?

If the noise floor stays high in a quiet room, or the mic sounds thin however you set it up, the mic may be the problem. Our guides lean on what owners say after months of recording with theirs.

Mic test questions

Is my audio recorded or uploaded?

No. The test runs in your browser. The short clip you record stays in this tab and is gone when you close or reload the page.

Why does my recording sound different from my voice?

When you talk, part of what you hear travels through the bones of your head, which adds low end. The mic only hears what travels through the air, like everyone else does. That's why most people find their recorded voice thinner than they expected.

Are these dB readings accurate?

They're dBFS, which measures how close the signal is to the loudest level your computer can record, with 0 as the ceiling. That's what you need to set gain and to compare your voice with room noise. It can't tell you how loud the room is in the usual decibel sense, because that takes a calibrated mic.

What level should I record at?

Aim for peaks between about −20 and −6 dB when you talk normally. That leaves room for laughs and loud words. A quiet recording is easy to turn up later, but a clipped one can't be repaired.

Does it work on a phone?

Yes, in current versions of Safari and Chrome. Phones often clean up the signal on their own, so the readings can look quieter than the room really is.